Страница 1 из 1
2ТЭ116 first series 3D Print on shapeways
Добавлено: Вт окт 10, 2017 11:23 pm
2TE10M
Re: 2ТЭ116 first series 3D Print on shapeways
Добавлено: Сб окт 14, 2017 2:38 pm
GuntisK
Very interesting. Somewhere there is also other Soviet/Russian locomotives with somewhat lower but still very good details. Also a bit cheaper than this model. It seems that its just a perfect time to start SLS 3D printer project. Some time ago I made FDM type 3D printer just to make parts for my models, but results show that FDM is not suitable for anything small. Only bogies for TEP70 and some parts for P36 were made with reasonable quality. Now its time to switch to laser sintering technology (I am mechatronic engineer and if there will be interest in these things maybe I can start a topic on DIY 3D printers
). And again- thanks for sharing that link.
Re: 2ТЭ116 first series 3D Print on shapeways
Добавлено: Сб окт 21, 2017 12:02 pm
ivan
Christoph, could you tell more about this model. Of cause, 2TE116 is model we need, but there is no any information, detailed pictures, etc.
Kind regards,
Ivan
Re: 2ТЭ116 first series 3D Print on shapeways
Добавлено: Вт окт 24, 2017 8:11 pm
2TE10M
Hi Ivan, I unfortunately have no more information. But will order the model next month. Then we know more!
Christoph
Re: 2ТЭ116 first series 3D Print on shapeways
Добавлено: Ср окт 25, 2017 12:10 pm
ivan
2TE10M писал(а): ↑Вт окт 24, 2017 8:11 pm
Hi Ivan, I unfortunately have no more information. But will order the model next month. Then we know more!
Christoph
Christoth, thank you very much! So, we will be waiting.
Kind regards,
Ivan